| Miami Water Heater has the best selection of Solar Water Heating Systems in South Florida.
From a replacment tank to an entire system and conversion, We have to solution to your solar needs. We are Rheem and Ruud Distributor with a full line of Solar Water Heaters and storage tanks. |
|
|
|
|
Because we carry such an extensive line of product,
click these links below for specifications.
Rheem Solar Water Heaters |
|
|
|
Call us for specifications on complete systems and solar panels or related equipment.
|
|
Call Us Today! Let us help you decide on a Solar water heating solution.
|
|
| |
|
| |
|
GUARDIAN WATER HEATERS PACKAGES
Each complete package kit includes the Guardian collector(s), mount(s). Guardian tank designated, Guardian controller listed
with sensors, pump listed with power cord, complete roof kit motorized ball valve, (2 ea.) color coded and drain valves,
(2) ½ tee ccf, (2) ½ x Ύ cf adapters (cast bronze) and (1) Ύ gate valve. Note: Freeze protection valves and air vents
may be interchangeable at slight adjustments in cost. The motorized ball valve CANNOT be swapped out. Check with your store manager for details.
THE GUARDIAN WATER HEATER This package consists of virtually everything needed to install the system which includes a
fabricated, soldered and boxed tank kit with individual piece as follows: No. 1 pre-soldered (hot to house) line extending
to back of tank. No. 2 a pre-soldered (cold to tank) line extending to the back of the tank which includes an isolation valve.
NO. 3- one each pre-soldered solar supply and return line which includes color coded isolation ball and drain valves, and a motorize ball/check
valve which virtually eliminates thermosyphoning for 5-10 years thereby reducing freeze damage normally attributed to faulty freeze protection
valves. No. 4 a Groundfos pump with cord kit. No. 5 one I.E. GL-30_LCO-X255 controller with 2 sensors and No. 6 a complete and
separately boxed roof installation kit which contains sealing penetrations, all necessary fittings for the collector(s) and valves which are
normally installed on the floor plus 90s and tees to tie them together. Each GUARDIAN WATER HEATER includes: ten sticks of ½ and one stick of Ύ x 6
Halstead Insulation, one 5/8 x 50 refrig. Coil, one set of 3/8 x 4 lag bolts w/ ss lock and flat washers per collector, one set of four each 8 x 8 galv.
Flashing or pitch pans, 50 of stranded sensor wire, two yellow wire nuts, four UY scotchlocks, two ceiling escutcheons, one roll of
electrical tape, two tubes of heat sink compound , four Ύ copper 90? ells, a ½ s.s. sensor hold down clamp and a jar of paint.
The model number is the system plus a G (GUARDIAN)
Click Here For More Info
| Model# |
Collector |
Tank |
Price |
| 80-40-G |
AE-40E |
80 |
$3,500 |
| 120-64-G |
2 (AE-32E) |
120 |
$4,900 |
| 120-80-G |
2 (AE-40E) |
120 |
$5,500 |
INSTALLATION MINIMUIM $1500.00 FOR THE 80 SYSTEM
INSTALLATION MINIMUIM $2000.00 FOR THE 120 SYSTEMS
SOLAR PANEL 24 VOLT AND 24 VOLT PUMP $150.00 ADDITIONAL
MIAMI WATER HEATER
1324 NW 29 th St.
Miami, FL 33142
Tel.(305) 633-2656 - Fax.(305) 633-0374
Contact us at sales@miamiwaterheater.com
|